Description

This extra large-sized hot tub jet is compatible with older tubs that have “thread-in” fittings including Beachcomber Hot Tubs prior to November 1999 (serial codes containing only numbers).

This motion massage jet offers a pulsating action as it rotates pressure over the 7 jet holes. You can adjust the jet pressure by opening and closing the jet with a ¼ turn clockwise (to close) or counterclockwise (to open).

Measures 4 ¾” across the face. Colour/Finish: Grey Plastic

This jet is discontinued by the manufacture. Limited stock is available.

Other Compatible Jet Options:

• None

To remove, put your fingers behind the face of the old jet in the hot tub and gently wiggle the jet face towards you so it slides forward about 1”. With the face extended away from the tub, grab the jet face and twist it counter-clockwise a few rotations until the jet can be removed freely.

To install, start by pushing the face forward 1” like when the old jet was removed. Push the center of the new jet into the fitting using your thumbs and rotate the jet clockwise spinning a few times until it is snug. Push the face forward so it is flush to the tub. Check for the ¼ turn open and close motion to verify the jet is installed correctly.

Always ensure the old jet is completely removed before installing the new one. If the old jet separates during removal where only the face comes out of the fitting, use needle nose plyers to rotate the remaining part of the old jet counter-clockwise until it can be removed. Then install the new jet.

Please contact us prior to purchasing your jets if you have any questions so we can help you select the correct ones.

Learn more about hot tub jets here