This extra large hot tub jet is compatible with older tubs that have “thread-in” RFM floor fittings including Beachcomber Hot Tubs from 2003 and prior (serial codes beginning with letters A to D or serial codes with only numbers). These Reflex Foot Massage jets are extremely powerful and deliver a deep tissue massage to your feet. The directional nozzle is adjustable to customize the position. Measures 5” across the face. Colour/Finish: Grey Plastic
This jet is discontinued by the manufacture, limited stock available.
Other Compatible Jet Options:
Note: This jet is not compatible or interchangeable with the E3 series 5”- 5 ¼” jets, the RFM Snap-in Grey jet or the RFM Snap-in Britewerx jet.
Size Comparison Guide:
AJ – 2”-2 ¼” across the face, small
E1 – 3”-3 ¼” across the face, medium
E2 – 3.5” across the face, large
E3 – 5”- 5 ¼” across the face, extra large
RFM – 5”- 5 ¼“ across the face, extra large
Neck Jet Grey – 2 5/8” across the face
Neck Jet Britewerx – 3 ¼” across the face
To remove, put your fingers behind the face of the old jet in the hot tub and gently wiggle the jet face towards you so it slides forward about 1”. With the face extended away from the tub, grab the jet face and twist it counter-clockwise a few rotations until the jet can be removed freely. To install, start by pushing the face forward 1” like when the old jet was removed. Push the center of the new jet into the fitting using your thumbs and rotate the jet clockwise spinning a few times until it is snug. Push the face forward so it is flush to the tub. These jets to not open and close like others in the hot tub. Always ensure the old jet is completely removed before installing the new one. If the old jet separates during removal where only the face comes out of the fitting, use needle nose plyers to rotate the remaining part of the old jet counter-clockwise until it can be removed. Then install the new jet. Always install the correct insert (included) inside the jet before installing the jet in the hot tub or the air will not pass through the jet properly. Use your old jet to reference which insert your should be using.
Please contact us prior to purchasing your jets if you have any questions so we can help you select the correct ones.