Description

This SMT Everlite 6 uses surface mount technology where the 36x RBG lights are installed directly on the circuit board. Everlite 6 gives you 6x lighting options:

• All Colours Rotating
• Freeze Mode
• Pulse Mode
• White
• a mode where the Everlite is off but the other lights are on
• a mode where the Everlite is on but the other lights are off

To change modes hit the “light” button on the control panel twice within 3 seconds which allows the user to scroll through the different lighting options. If the light is left on it will automatically turn off in a few hours. If your hot tub has 4 lighting options instead of 6, please refer to the Everlite 4.

Installation Tips:

If the light housing has leaked consider the paper towel test. Place a paper towel sheet where the light would go, fasten the front lens so the housing is sealed, fill the tub so the housing is underwater, leave it for a day or 2, then drain, open the housing and check if the paper towel is wet or dry. If it is dry the housing is not leaking and you are good to replace the new light. If the paper towel is wet there is a leak to fix, do not install the light until you can do the test and everything is dry as the bulb will malfunction if it gets wet.

Items that you might need

Hot Tub Light Lens – sometimes the inner light lens can get damaged during removal where it may need to be replaced

Hot Tub Light Lens O-Ring – like most o-rings these seldom fail however if needed it’s here for you