Description
BioGuard Sparkle Up is the strongest filter aid and is intended to be used to remove metals or extremely small particles. By enhancing your filters performance, Sparkle Up is able to aid in the removal of metals, which will also prevent staining as well as remove tiny particles from the pool such as: dirt, plaster dust, dead algae, pollen, and other small bits of debris.
Available size: 750g
How to Use Sparkle Up with a Sand Filter:
- Backwash filter for 3 – 5 minutes and return to filtration
- Use the table below to figure out how much Lo ‘n Slo to add to your pool.
Filter Tank Diamter 18″ 24″ 30″ 36″ 42″ Amount needed 100g 160g 240g 360g 520g - Run Pump Continuously
- Mix product with water to make a slurry and add slowly to the skimmer
- 24 hours later backwash your filter or when it reaches the maximum pressure recommended by the manufacturer
How to Use at Sparkle Up with a Cartridge Filter:
- Remove filter cartridges and clean them
- Return cartridges to filter
- Add 320g of Sparkle Up for every 97 square feet of filter material
- Run pump continuously
- Mix product with water to make a slurry and add slowly to the skimmer
- 24 hours later clean your filter cartridges or when it reaches the maximum pressure recommended by the manufacturer
DO NOT USE SPARKLE UP WHILE SWIMMERS ARE IN THE POOL
Wait 15 minutes after applying Sparkle Up to go swimming
Tips for Using Sparkle Up
- The scoop inside the Sparkle Up container will hold 40g of Sparkle Up if you level off the product
Complimentary Products
- Pool Magnet Plus will prevent metals from staining your pool while you use Sparkle Up to remove them
- Use Filter Brite to clean filters after using Sparkle Up to get rid of the trapped metals